[AIR-CR] How do I connect Exit Button and Door Sensor?

[AIR-CR] How do I connect Exit Button and Door Sensor?

Use the wiring example shown in the figure below.
  1. Connect the wires coming from the exit button to GND (black wire) and EXIT (blue wire).
  2. Connect the wires coming from the door sensor to GND (black wire) and DPS (pink wire).

  1. If the wires on the output button side are connected to the COM and NO (normally open) terminals, set the CLOSE condition in the controller settings.
  2. If the wires on the output button side are connected to the COM and NC (normally closed) terminals, set the OPEN condition in the controller settings.
  3. If the correct condition corresponding to the button type is set, the controller output will be activated when the button is pressed, not when it is released.
  4. If a magnetic door sensor is connected, set the OPEN condition in the controller settings.
  5. If you are using a special sensor, select the condition corresponding to its activation type.


    • Related Articles

    • [ICON-Pro] How do I connect Door Sensor and Exit Button?

      Use the wiring example shown in the figure below. Connect the wires coming from the door sensor to the free GND and Contact terminals. In the settings of the Door Sensor resource, select Input - Contact and specify the OPEN condition when the event ...

    • [AIR-CR] How do I connect Motion Detector Request-To-Exit (RTE)?

      Use the wiring example shown in the figure below. Connect the wires coming from the PIR Request to Exit motion sensor relay to GND (black wire) and EXIT (blue wire) on the controller. If the wires from the motion sensor relay are connected to the COM ...

    • [AIR-CR] How do I connect Ethernet?

      To connect the AIR-CR device to the Internet via Ethernet, follow these steps: Prepare Ethernet Cable: If not already done, strip the Ethernet cable to expose the individual wires. Connect Ethernet Wires: Match the colors of the Ethernet wires to the ...

    • [ICON-Pro] How do I connect Motion Detector Request-To-Exit (RTE)?

      Use the wiring example shown in the figure below. Connect the wires coming from the PIR Request to Exit motion sensor control relays to the free GND and REX terminals on the controller. If the wires from the motion sensor relays are connected to the ...

    • [AIR-CR] How do I connect an Electric Lock?

      Use the connection example shown in the figure below.