[ICON-Pro] How do I connect Motion Detector Request-To-Exit (RTE)?

[ICON-Pro] How do I connect Motion Detector Request-To-Exit (RTE)?

Use the wiring example shown in the figure below.
Connect the wires coming from the PIR Request to Exit motion sensor control relays to the free GND and REX terminals on the controller.

If the wires from the motion sensor relays are connected to the COM and NO (normally open) terminals, set the CLOSE condition in the controller settings.
If the wires from the motion sensor relay are connected to the COM and NC terminals (normally closed button condition), set the OPEN condition in the controller settings.

If the correct condition corresponding to the type of connection is set, the relay will be activated when motion is detected, not after it has ended.


    • Related Articles

    • [AIR-CR] How do I connect Motion Detector Request-To-Exit (RTE)?

      Use the wiring example shown in the figure below. Connect the wires coming from the PIR Request to Exit motion sensor relay to GND (black wire) and EXIT (blue wire) on the controller. If the wires from the motion sensor relay are connected to the COM ...

    • [ICON-Pro] How do I connect Door Sensor and Exit Button?

      Use the wiring example shown in the figure below. Connect the wires coming from the door sensor to the free GND and Contact terminals. In the settings of the Door Sensor resource, select Input - Contact and specify the OPEN condition when the event ...

    • [ICON-Pro] How do I connect an Electric Lock?

      Use the connection example shown in the figure below.

    • [ICON-Pro] How do I connect a Reader?

      Connecting a reader to the Wiegand interface. Use the connection example shown in the figure below or refer to the manufacturer's manual of the device to be connected. Connection of the reader to RS-485 interface via OSDP protocol. Use the connection ...

    • [AIR-CR] How do I connect Exit Button and Door Sensor?

      Use the wiring example shown in the figure below. Connect the wires coming from the exit button to GND (black wire) and EXIT (blue wire). Connect the wires coming from the door sensor to GND (black wire) and DPS (pink wire). If the wires on the ...