[AIR-CR] How do I connect Ethernet?

[AIR-CR] How do I connect Ethernet?

To connect the AIR-CR device to the Internet via Ethernet, follow these steps:




Prepare Ethernet Cable:
  1. If not already done, strip the Ethernet cable to expose the individual wires.
Connect Ethernet Wires:
  1. Match the colors of the Ethernet wires to the corresponding pins on the RJ-45 adapter (optional accessory).
  2. Connect Blue* to the TX- (pin 6).
  3. Connect Gray* to the TX+ (pin 3).
  4. Connect Orange* to the RX- (pin 2).
  5. Connect White* to the RX+ (pin 1).
Verify Connections:
  1. Make sure that the Ethernet wires are firmly attached to the appropriate pins on the RJ-45 adapter.
Connect RJ-45 Adapter to Network:
  1. Connect the Ethernet cable from the router to the RJ-45 adapter.

    • Related Articles

    • [AIR-CR] How do I connect Motion Detector Request-To-Exit (RTE)?

      Use the wiring example shown in the figure below. Connect the wires coming from the PIR Request to Exit motion sensor relay to GND (black wire) and EXIT (blue wire) on the controller. If the wires from the motion sensor relay are connected to the COM ...

    • [AIR-CR] How do I connect Exit Button and Door Sensor?

      Use the wiring example shown in the figure below. Connect the wires coming from the exit button to GND (black wire) and EXIT (blue wire). Connect the wires coming from the door sensor to GND (black wire) and DPS (pink wire). If the wires on the ...

    • [AIR-CR] How do I connect an Electric Lock?

      Use the connection example shown in the figure below.

    • [AIR-CR] How do I connect a Reader?

      Connecting a reader to the Wiegand interface. Use the connection example shown in the figure below: Connection of the reader to RS-485 interface via OSDP protocol. Use the connection example shown in the figure below:

    • [ICON-Pro] How do I connect Door Sensor and Exit Button?

      Use the wiring example shown in the figure below. Connect the wires coming from the door sensor to the free GND and Contact terminals. In the settings of the Door Sensor resource, select Input - Contact and specify the OPEN condition when the event ...