[ICON-Pro] How do I connect a Reader?
Connecting a reader to the Wiegand interface.
Use the connection example shown in the figure below or refer to the manufacturer's manual of the device to be connected.
Connection of the reader to RS-485 interface via OSDP protocol.
Use the connection example shown in the figure below:
Related Articles
[ICON-Pro] How do I connect Door Sensor and Exit Button?
Use the wiring example shown in the figure below. Connect the wires coming from the door sensor to the free GND and Contact terminals. In the settings of the Door Sensor resource, select Input - Contact and specify the OPEN condition when the event ...[AIR-CR] How do I connect a Reader?
Connecting a reader to the Wiegand interface. Use the connection example shown in the figure below: Connection of the reader to RS-485 interface via OSDP protocol. Use the connection example shown in the figure below:[ICON-Pro] How do I connect Motion Detector Request-To-Exit (RTE)?
Use the wiring example shown in the figure below. Connect the wires coming from the PIR Request to Exit motion sensor control relays to the free GND and REX terminals on the controller. If the wires from the motion sensor relays are connected to the ...[ICON-Pro] How do I connect an Electric Lock?
Use the connection example shown in the figure below.How to connect Master Device Wireless Wiegand to ICON-Pro controller?
Connections must be made using wired connections. Use the connection example shown in the figure below.