How to connect Master Device Wireless Wiegand to ICON-Pro controller?

Connections must be made using wired connections.

Use the connection example shown in the figure below.

​

• Related Articles

• WW Wireless Wiegand: List of supported devices.

  Wireless Wiegand is designed to support readers that strictly adhere to Wiegand or OSDP standards. Generally, all HID, Wavelynx, and Brivo readers—along with many others that properly implement these standards—work seamlessly with the system. Because ...

• ICON-PRO: List of supported readers

  ICON-PRO supports most Wiegand and OSDP readers that follow the applicable standards. Only the readers listed below have been tested; compatibility, behavior, and features may vary by reader model and configuration.

• [ICON-Pro] How do I connect a Reader?

  Connecting a reader to the Wiegand interface. Use the connection example shown in the figure below or refer to the manufacturer's manual of the device to be connected. Connection of the reader to RS-485 interface via OSDP protocol. Use the connection ...

• [ICON-Pro] How do I connect Motion Detector Request-To-Exit (RTE)?

  Use the wiring example shown in the figure below. Connect the wires coming from the PIR Request to Exit motion sensor control relays to the free GND and REX terminals on the controller. If the wires from the motion sensor relays are connected to the ...

• [ICON-Pro] How do I connect Door Sensor and Exit Button?

  Use the wiring example shown in the figure below. Connect the wires coming from the door sensor to the free GND and Contact terminals. In the settings of the Door Sensor resource, select Input - Contact and specify the OPEN condition when the event ...